Check out some similar questions!

cplbpd · Oct 28, 2009, 08:30 AM

My Craftsman DYT 4000 with 24 hp craftsman engine started to run high/low/high/low then cut off. I can get it to run on full choke although it will stall if I move it. I replaced the fuel pump, filter, fuel, cleaned the carb (odd type of carb) and cannot get it to run right. Plugs are color of greyish to brown. When it does run it will idle all day, will not work past 2 minutes of mowing, then dies out. Because the needle valve is plastic and the carb is different than the older styles, there is no air fuel adjustment screw or anything that I could tinker with to try and get it running. Any Clues?

ballengerb1 · Oct 28, 2009, 08:52 AM

There is no Craftsman engine, is it a Briggs or a Kolher? Sears model number is under the seat, that would help us.

jsfocke · Oct 28, 2009, 01:33 PM

Did you check the vent in the gas cap?

cplbpd · Oct 28, 2009, 01:40 PM

Originally Posted by cplbpd

My Craftsman DYT 4000 with 24 hp craftsman engine started to run high/low/high/low then cut off. I can get it to run on full choke although it will stall if I move it. I replaced the fuel pump, filter, fuel, cleaned the carb (odd type of carb) and cannot get it to run right. plugs are color of greyish to brown. When it does run it will idle all day, will not work past 2 minutes of mowing, then dies out. Because the needle valve is plastic and the carb is different than the older styles, there is no air fuel adjustment screw or anything that I could tinker with to try and get it running. Any Clues?

Sorry about that, it is a Briggs and Stratton. I have checked the vent on the gas cap also, with the cap off no change. Thanks

cplbpd · Oct 28, 2009, 01:41 PM

Originally Posted by jsfocke

Did you check the vent in the gas cap?

Checked it no difference with the cap on or off. Thanks

Highmoor · Apr 16, 2010, 10:34 AM

I am having the same problem with my DYT 4000 Briggs & stratton 24 horse any suggestions?