Ask Experts Questions for FREE Help !
Ask
    crazy_russian's Avatar
    crazy_russian Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Apr 9, 2010, 09:59 AM
    Carrier furnace model 394JAZ060080AAFA blower problem
    Carrier furnace model 394JAZ060080AAFA ( about 19 years old)


    Fan (blower) comes on for two more short bursts after it shuts off during a heat cycle. I tried replacing the thermostat, but this was not the problem.

    This is not stopping me from getting heat (yet), but it is annoying.

    Any ideas? Time delay? Or?
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Apr 9, 2010, 10:48 AM
    Usually that is caused by residual heat that builds up after the blower shuts off the first time after a heat cycle. A fan/limit OR fan control is possibly the problem. If they go out of calibration then they shut off to soon allowing the residual heat situatioin to happen. Naturally I am sure that you already checked ALL the registers in the home are open and the air filter is clean with no restrictions since this can also cause a problem.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Carrier furnace model 58STA090-14 [ 1 Answers ]

Error code 14 is displaying. When I turn off power and turn it back on the furnace ignites, all burners light and furnace heats until thermostate desired temperature is reached. I cleaned the flame senser with steel wool. The furnace works okay for a time or two again then repeats the error code...

Carrier furnace: limit switch fault furnace has ignition but blower will not come on? [ 2 Answers ]

Board says it is a limit switch fault Furace goes into pre ignition, fan comes on and sometimes even the main burner ignites, but the blower will not come on... is this the blower motor or could this be a switch somewhere?

Carrier Furnace model 58MVP [ 9 Answers ]

My carrier furnace model 58MVP broke down this morning. Fault code is "4-2" - inducer rpm out of normal range. Any suggestions on how to obtain a new module and how involved the repair is? Have scheduled a service appointment, but no one can get her for at least next day at best. Thank you

Carrier furnace problem [ 5 Answers ]

My carrier furnace would only come on if I shut down the main power then turned it back on. Then after it got up to the proper temperature it would shut off but not come back on. Now it won't come on at all. I just replaced the control board and it is doing the same thing.

Carrier model 58gs050-2 blower won't turn on [ 0 Answers ]

Carrier model 58gs050-2 blower won't turn on. The fire is burning but the blower isn't doing anything.

View more questions Search