Ask Experts Questions for FREE Help !
Ask
    kgreen812's Avatar
    kgreen812 Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Apr 3, 2010, 10:40 AM
    Goodman gmp050-3 Burner Shuts Off before heating
    The furnace control board went bad and has been replaced. The new issue... it will not stay burning through a heating cycle: 1. thermostat calls for heat. 2 induced draft blower starts. 3 ignitor activates. 4 audible click, gas introduced with light off... burns for 1-2 seconds(indoor blower begins its cycle) followed by audible click and gas shut off. 5 induced draft blower shuts down. 6 Then the same cycle restarst again.
    Joshdta's Avatar
    Joshdta Posts: 2,549, Reputation: 45
    Ultra Member
    		  
    #2

    Apr 3, 2010, 02:31 PM

    Drity flame sencer and too much gas pressure will cause this
    kgreen812's Avatar
    kgreen812 Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Apr 6, 2010, 11:33 AM

    In addition, there is 24 volts when gas is called for, within 1 second the power is cut and gas flow is interupted.
    mygirlsdad77's Avatar
    mygirlsdad77 Posts: 5,713, Reputation: 339
    Plumbing Expert
    		  
    #4

    Apr 6, 2010, 03:21 PM

    As Josh mentioned, I would start by cleaning the flame senser
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Need help with a goodman furance gmp050-3 [ 1 Answers ]

It is goodman gmp050-3. the red light blinks 3 times. I have replaced the pressure control switch and the thermostat. But still no change. Could I have gotten a bad pressure control switch. What else could it be? HELP

Furnace burner shuts off too quickly [ 1 Answers ]

We have a payne gas furnace that is approx. 14 years old. The burner ignites, burns for about 10 seconds and then the blower kicks on and blows for about three minutes. The process then repeats itself. We have already tried a new thermostat, to no avail. Any suggestions as to what could be causing...

Gas incinerator shuts off burner [ 1 Answers ]

I have a old incinerator that shuts down adfter about 5 minutes of operation. I noticed the pilot light was off and I couldn't get it to re-light. I installed a new thermocouple. Now the pilot will stay lit but several minutes after the main burner has been activated I hear a distinct click and all...

Fuel odor after burner shuts off [ 3 Answers ]

We have a Miller Kerosene Mobile home furnace. It runs fine! However after the burner shuts off and the blower is still on we smell burnt kerosene. I went outside while it was firing and the smoke is clear but the chimney cap is all sooty. We have noticed a thin black soot on the appliances in the...

Burner shuts off before blower turns on [ 1 Answers ]

My 4-5 year old rheem furnace has a problem. Everything seems fine until the burners start up. They fire up, but only stay on for about 3 to 8 seconds, then the blower turns on but only puts out cold air. I don't think it's an ignitor problem because the burner always ignites. It just started doing...

View more questions Search