 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Generac G27H pressure Washer Briggs&Stratton
I am trying to change or check the oil level for the pump side of this pressure washer. I have 3 plugs to add oil the two on the mid section of the engine yellow and a white one 3/4 of the way up on the engine.
I drained the oil yesterday and purchased a quart of the non dertegent oil for the pump so I thought the fill closest to the pump would be for the pump, so I kept filling and filling and it all went to the main crankcase, so I drained it out. Why the 3 filler plugs? Do they all go to the same spot? How do I change the oil for the pressure pump? The engine is a Briggs and Stratton Interteck 206 |
||||
Check out some similar questions!
I have a Generac G27H pressure Washer with a 6.5 Briggs and Straton engine Intek. The fuel tank has developed a leak and was wondering if anyone knows of a recall for this fuel tank? Or a good repair solution? Thanks Rodney Robbins
I re built the b&s engine on my craftsman pressure washer the motor starts right up and runns fine until I pull the triger then it bogs really bad but stays runningany sudjestions on what the cause might be would be much appreicated.
I somehow managed to run out of oil on the power washer... it was smoking & had a bad smell. Put oil in, & now won't start... it will turn over, but not catch. Probably ran without oil for about 10-25 minutes.:confused:
Does anybody know can anybody tell me how much oil this engin should take ? Thanks skippy
I recently purchased a used B & S pressure washer. It starts up and runs fine. However, I have not been able to pump any detergent through the system. Can someone tell me what I am not doing?
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
