[jrobigolf]

I tried to replace a leaking shutoff valve on the toilet at a friend's house. The valve is old and quite corroded. The replacement she already had was a screw on with 1/4 turn on/off handle... no compression fitting on main inlet side. The supply line is PVC pipe. After shutting off water and disconecting the toilet fill line, I tried to unscrew the entire valve from pipe. It turns but does not back out. Is there a way to unscrew the valve from the inlet pipe? With all the corrosion I cannot tell if the old valve screws into the metal nut around the pipe or if it is one piece like the replacement valve. If it is two pieces (valve and attatchment nut) and highly corroded, what is best way to break apart. Not much room to work as I'm sure is common for these. Thanks!

[afaroo]

Jrobbigo,

See the image below and it will show hot to remove a compression type angle valve, before you remove the valve make sure to turn off the water, if that will not work for come back and tell us how far is the pipe out from the wall if there is enough pipe remaining you may need to cut the pipe to remove the old angle valve and install a new one good luck.

John

Sorry Jrobbigo,

I reread your post I am a little bit confused, please take a picture of the valve and posted, Thanks.

John