Ask Experts Questions for FREE Help !
Ask
    jchristi's Avatar
    jchristi Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Mar 10, 2010, 11:40 AM
    Tub spout nipple length dilema
    I want to replace my tub spout. The nipple is a 1/2" copper pipe with 3/4" threads soldered on the end, giving it a total clearance of 3.5" to the end of the pipe. I can't seem to find any replacement spouts that will fit.

    Should I cut the threads off and attach a slip-on spout or is there a threaded extension piece allowing a spout with a larger required clearance to screw on?

    Thanks
    afaroo's Avatar
    afaroo Posts: 4,006, Reputation: 251
    Ultra Member
    		  
    #2

    Mar 10, 2010, 11:59 AM

    There are basically two kinds of tub spouts with diverters... the threaded kind and the slip on kind (see pictures below). The slip on type spout is missing the diverter in this picture but presents the idea for you to see it.

    To install a slip type make sure to cut the pipe to the correct size see the images below, de burr the end of the copper pipe, use a little silicone GREASE to lubricate the new Oring just prior to installation so the new Oring doesn't bind and break, the Oring is inside the tub spout, good luck.

    John
    Attached Images
      
    Milo Dolezal's Avatar
    Milo Dolezal Posts: 7,192, Reputation: 523
    Plumbing Expert
    		  
    #3

    Mar 10, 2010, 12:31 PM

    Don't waste your time trying to find the spout that will fit. As you said: cut off the threads. Install new Slip-On spout following John's instructions.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

New tub length is off [ 2 Answers ]

I set my new fiberglass tub into position to see how it would work and I am coming up about 1/2 short in the rear. I know I can place a shimmy behind it, but I was going to tile all around the tub. Won't this throw off my measurements for the tile? Any ideas? ...

Tub faucet leaking from back. Nipple length wrong? [ 6 Answers ]

We just had new copper pipes installed and are trying to attach our new tub faucet (Delta Universal Trim.) When we attach the faucet so that its flush to the wall, water leaks from the back. When we pull it away from the wall about 1/4", the leak stops. All we did to install it was slip the...

Tub spout [ 2 Answers ]

I have a tub spout with a diverter the diverter has to remain up or else I will leak down my basement. Now it leaks every time after a shower. Help

Tub spout [ 2 Answers ]

Can a spout with a pop-up knob be used to replace a normal spout that didn't have a pop-up from the beginning ?

Tub Spout [ 3 Answers ]

I have an old tub spout with diverter that I am trying to replace. The pipe underneath has a 1 1/4" adapter attached that has been in place for 10 years. My question is how do I remove that adapter? I know heating it is an option, but what should I use that won't melt the plastic tub wall, and how...

View more questions Search