Ask Experts Questions for FREE Help !
Ask
    igy's Avatar
    igy Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Mar 9, 2010, 03:03 PM
    Wesco furace paerts in everett WAshingnto?
    Parts for wesco furnase in everett WAshington?
    igy's Avatar
    igy Posts: 2, Reputation: 1
    New Member
    		  
    #2

    Mar 9, 2010, 03:06 PM

    Where I can fined wesco furece parts in everett Washington?
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #3

    Mar 9, 2010, 03:41 PM
    Wesco is out of business for some time. You might find some parts on Ebay since that is where I found some or do a Google. The parts are not on Ebay all the time.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Furace fan won't stop unless furnace is shut off [ 8 Answers ]

Hi, I have Heil Ultimate II gas furnace with about 13 yrs old. The furnace is working OK except the fan would never stop as long as the furnace is on, therefore, it will blow the cold air when the heating stops. I also tried to disconnect the wire from the board, and fan will still not stop. ...

Heil furace parts [ 2 Answers ]

Have a Heil furace in garage start up blower start glow plug starts burner come up to temp fan starts may run for 2 min to 5 min. shuts off before it get up what the themostat is set at it will keep doing this cycle.What could be something to check?

My burner on my evcon furace goes out when fan comes on [ 3 Answers ]

What's wrong

Intertherm Furace [ 4 Answers ]

I have an Intertherm furnace with electronic ignition. When it kicks on it only burns for a couple of seconds. I have changed the module, gas valve, igniter,checked the exaust flue, and thermostat... Whats up, I'm stumped. monkeypud:confused: :confused:

WESCO UEM,allways on now [ 1 Answers ]

I have a WESCO uem 20kw electric furnace, about 25 yrs old, It had a single temp stat first then a setback stat was installed, with a box added to the furnace controls, the set back stat failed after a few years so I put the original single temp stat back and it worked for years now, a while back...

View more questions Search