Check out some similar questions!
Heil SP80 Draft Inducer Motor Cycling On/Off
[ 1 Answers ]
Hello, I have a Heil SP80 natural gas induced draft fan furnace, model # NUG5075BFB2. The unit fires up normally and all is well until the unit shuts off when the temperature setpoint is reached. The draft inducer motor then cycles on and off shortly after the flame is shut down and for 20...
What causes hot water tanks thermostats to overheat then have to be reset
[ 3 Answers ]
Our Electric hot water tank (age unknown) has been overheating then kicking off the reset on the thermostat block. I turned the temperature down on the hot water tank thermostat and then pressed the reset. The water again over heated and has shut it's self down again. The obvious is the thermostat...
Furnace's draft motor keep running
[ 5 Answers ]
Hi, My furnace recently starts acting weird. After running up to satisfied temperature, the thermostat stops normally, then the blower stops 30 seconds later as usual, but the draft motor sometimes keep on running forever. Turn off then on the power to furnace obviously reset it to normal,...
The draft motor runs continiously
[ 3 Answers ]
Hi, I have a 80% efficient furnace and I am having the following trouble with the heat. The draft motor starts running the moment I power on the furnace. Its had been running during the summer time also when the I just was using AC. Being new to these things I did not realize that it was a...
Goodman furnace induced draft motor
[ 3 Answers ]
On a call for heat the draft motor starts but the air proving switch does not close. I replaced it with the same result. Everything works normally if I close the switch manually with my own air pressure. Someone told me that somethimes the motor, due to age (this one is 13 years) will not spin fast... View more questions Search
Add your answer here.
|