 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
I have a Rheem Corsair 90%, burners intermittent, replaced about everything...
5 yr old corsair 90%er burners flash on, then burp, and run then burp, then kicks out and goes to lock out... I've replaced about everything... control panel, pressure switches, gas valve (twice), heat sensor rod, hot wired around thermastat...
|
||||
Check out some similar questions!
I have looked at the other discussions about the Rheem II and have an additional problem. The Heater (only heater I don't have AC) tends to be a little troublesome at times. I tested the vacuum for the blower relay as suggested in another forum. I hear clicks both ways. This is what I have...
My furnace quit working on me two days ago. After some troubleshooting, I discovered my glow ignitor was shot. Replaced that, new one works, and the furnace sort of worked. First burner lit for a couple of seconds and then quit. The other four did not light. The flame sensor is on the last...
I have a new motor, thermostat is only a year and a half old, heat comes on, burners won't stay lit. Getting faint heat from vents on first floor level of house
I have an older Rheem gas hot water boiler heater - pilot is on, and I have turned up the thermostat, which appears to be working (saw a spark in the mercury when I turned it up) - burner is not coming on - what's wrong?
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
