Ask Experts Questions for FREE Help !
Ask
    vegasdude's Avatar
    vegasdude Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Feb 21, 2010, 11:37 PM
    Goodman furnace cracks near fire inlets
    My Goodman Air/Furnace has cracks in the metal near where the fire blows into. Is this normal? Should it be a worry? I have tested numerous times and locations in the house for carbon monoxide and found zero every time. By the way, the unit works great and is about 10-12 years old.
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Feb 22, 2010, 03:37 AM
    Post pictures since some areas can be a problem.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Goodman GDS80904BNA won't fire [ 0 Answers ]

I have a Goodman GDS80904BNA with electronic ignition - I replaced the igniter and cleaned the sensor rod, but it still won't ignite, even though the blower runs. The main fuse and the 3-amp fuse on the control panel are not tripped - the red error LED is burning steady - no flashes. Do I need to...

Hot water tank inlets leaking [ 3 Answers ]

My father and I installed a new water heater this weekend and the cold water inlet and hot water outlet is slowly leaking, how do I fix this problem?

Goodman GMPN won't fire [ 3 Answers ]

Trying it for the first time this year, unit is 9 years old. The furnace blower keeps running but there's no fire and after a few minutes it cuts off. LED is solid. Could the ignition switch be shot? Thanks.

Goodman Furnace Issue - Heater won't work, no fire [ 1 Answers ]

My Goodman heater won't fire up. When I turn the heat on, the sequence of events: 1) Small fan at top section turns on. 2) Heating element turns on, bright red. The system sounds like it is trying to turn on. 3) Then the bright red goes off. The fire does not light. The fan does not start 4)...

Goodman Furnace won't keep fire up [ 2 Answers ]

I have a Goodman GMP100-5, age uncertain, maybe 6 years. The burner fired up for 7 seconds or so and turned off. After 3 cycles it went off. The status light blinked once. Since the gas fired OK. I replaced the flame sensor. It still does the same thing after the flame sensor replacement. It is a...

View more questions Search