 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Goodman GDS80904BNA won't fire
I have a Goodman GDS80904BNA with electronic ignition - I replaced the igniter and cleaned the sensor rod, but it still won't ignite, even though the blower runs. The main fuse and the 3-amp fuse on the control panel are not tripped - the red error LED is burning steady - no flashes. Do I need to replace the control board? Thanks.
|
||||
Check out some similar questions!
California state law requires 100 feet of vegetation clearance with 30' cleared and 70' reduced veg. The local fire district is saying all 100' must be cleared. Can the local regulation be stronger than the state? Thank you for any help.
Trying it for the first time this year, unit is 9 years old. The furnace blower keeps running but there's no fire and after a few minutes it cuts off. LED is solid. Could the ignition switch be shot? Thanks.
My Goodman heater won't fire up. When I turn the heat on, the sequence of events: 1) Small fan at top section turns on. 2) Heating element turns on, bright red. The system sounds like it is trying to turn on. 3) Then the bright red goes off. The fire does not light. The fan does not start 4)...
I have a Goodman GMP100-5, age uncertain, maybe 6 years. The burner fired up for 7 seconds or so and turned off. After 3 cycles it went off. The status light blinked once. Since the gas fired OK. I replaced the flame sensor. It still does the same thing after the flame sensor replacement. It is a...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
