 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Concord 90 plus furnace, open pressure switch error
I just replace filter, checked air passages, checked hoses. Still getting a 3 light error. The blower kicks on but the glow plug will not glow and the systems times out then goes to 3 light error. I can blow into orange tube and here the switch click. Is the switch defective? Or is it something else.
|
||||
Check out some similar questions!
I have led light flashing three times it mean pressure switch open with inducer on
I get three red flashes from the furnace after an attempt sequence when the t-stat calls for heat. The motor starts, and seems to try to light but after about thirty seconds, it quits and gives the error code. I have removed both gray tubes from the pressure switch and made sure they are...
I have a Concord 80 plus furnace. The code I'm getting is Limit or rollout switch open. The burner goes out after a few minutes and the blower motor keeps running. If I wait it resets itself after 15 minutes it will do it 3 times then it won't reset for an hour. I found two limits on each side of...
I have a Concord 80 Plus Gas Furnace. I am starting the furnace for the winter and it gives me a LED code of open limit switch or limit switch circuit. Everything seems to work fine up until the point where the blower needs to turn on. I had the same problem last year but got a tech to fix it. I am...
I have a Tempstar furnace that's reading a/an open pressure switch code. How do I correct this issue?
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
