Ask Experts Questions for FREE Help !
Ask
    wlkelly98's Avatar
    wlkelly98 Posts: 1, Reputation: 1
    New Member
     
    #1

    Feb 14, 2010, 09:02 AM
    Honeywell vision pro 8000 installation
    I have a Trane Model XR 90 High Efficiency, 100,000 BTU’s to heat a two-floor space with about 1900 square feet. When the outside temp. is around 20 degrees F and I set the thermostat to Hold at 63 degrees during the nighttime, when I get up the thermostat is reading 60 degrees. It cannot keep the temp. at the pre-set 63 degrees even though it runs most of the night. It takes the sun shining in my windows several hours later before it brings the house temperature to normal setting of 67. Can someone give me some ideas what's wrong? Thanks.
    KC13's Avatar
    KC13 Posts: 2,556, Reputation: 99
    Ultra Member
     
    #2

    Feb 14, 2010, 10:14 AM

    It sounds like the furnace is struggling to sustain heating cycles through the night. Try this: increase your night setback temp to 67 for a couple nights, to see if the indoor temp is maintained or if it decreases during the night. Observe the furnace during the morning recovery - if burner cycles are short/interrupted/frequent, a problem exists.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Vision pro 8000 screen comes up as EE, have troubleshooted as said in the manual? [ 4 Answers ]

Ive got a vision pro 8000 thermostat, a few days ago the screen came up as EE I had changed the batteries in the back and got it working again, however I got the same problem yesterday and even though I changed the batteries the sign came up again after a few hours any help?

Honeywell pro 8000 screen froze [ 1 Answers ]

Honeywell pro 8000 touch screen froze and will not let mey change the temp settings

Switching from robertshaw CM260 to a honeywell vision pro 8000 [ 2 Answers ]

I am switching from a Robert Shaw cm 260 to a Honeywell vision pro 8000 (TH832OU1008 and on my Robert Shaw there is a spot for a white wire that connects to "O" but that is no where on my honeywell? Where does that wire go?

Can the Honeywell Pro 8000 be intergraded [ 1 Answers ]

With a NetStreams home automation system? Thanks for any and all help. Dl

Honeywell Vision Pro 8000 TH8320 wiring [ 8 Answers ]

Hello, I have a 2-stage heat, one stage cool heat pump. I am trying to wire this thermostat but it is not working. I called a professional and she told me to wire it as follows, but the heat will never kick on no matter how long I wait. Left Side Heat Pump Y2-No wire L-No wire E-No wire...


View more questions Search