Ask Experts Questions for FREE Help !
Ask
    scottsteam's Avatar
    scottsteam Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Feb 8, 2010, 09:35 AM
    York heater 80 ignitor
    York 80 heater... cycles up... fan blower, coil glowing bright... gas control clicks... (no flow of gas hissing)... cycles down... (three times and indicator light signals once for "check furnace"
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Feb 8, 2010, 11:29 AM
    Check 24 volt power to gas valve during operation.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Honeywell Ignitor for Pool Heater S8600F ? [ 0 Answers ]

Hi, I have a pool heater natural gas with no pilot burner spark. I took the burner out and cleaned the orifice and can see light through it. The spark ignitor looks in good shape but? I can use a long Bic lighter to light the pilot and then the main valve comes on. I was told if I pull the spark...

York Diamond 80 Ignitor works abd blower runs but does not heat up house [ 3 Answers ]

Our basement unit York Diamond 80 runs and run with the ignitor working and the blower running but does not heat up the first floor. The unit in the attic heats the first floor fine. The exhaust vent seems to be extremely hot. Is it possible the motor that exhausts the cabon monoxide from the gas...

Need to replace an old york heater [ 3 Answers ]

I have a york 2 stage heater model 36c03 that needs to be replaced. It is emitting carbon monoxide. I can't find anything online even similar to what I have and I'd like an idea of the cost. My York was installed in 1979. Any ideas on what I should look for?

Heater york [ 1 Answers ]

Troubleshooting pressure switch stuck open on a york heater.

I need a new heater coil and ignitor [ 3 Answers ]

My a/c guy told me I need a new heater coil and ignitor, but its going to be expensive. I am handy and electronically and mechanically inclined, can someone help me do it myself? Thanks!

View more questions Search