Ask Experts Questions for FREE Help !
Ask
    Hinesjl's Avatar
    Hinesjl Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Feb 6, 2010, 07:04 AM
    Why does my central heat stay on after the theromostate has reached it's temp
    Hello, my question is about my heating and air, I am having problems with it not turning off when the temp is reached, it will continue to run, and I was wondering could you tell me what's wrong?
    Stratmando's Avatar
    Stratmando Posts: 11,188, Reputation: 508
    Uber Member
    		  
    #2

    Feb 6, 2010, 07:16 AM

    Thermostat would be first check. If removing hot from thermostat turns unit off, it IS the thermostat.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Central heat not reaching set temp and turns off [ 2 Answers ]

Thermostat set at 75 but showing 65 in the house heat will run but turn off not reaching what is set on thermoststat turns off for 1 minute and turns back on not heating to maximum.

A/C won't shut off once desired temp is reached [ 5 Answers ]

I recently changed out my old mercury thermostat to a Honeywell RTH3100C digital non-programmable thermostat. The issue I'm having is that once the desired temperature is reached on the thermostat the a/c won't shut off. What could be the issue?:(

Heat not turning off when temp. Reached? [ 2 Answers ]

Hello, I have a hot water boiler and a Honeywell CT3500 programmable thermostat (just moved in). The heat works, but does not turn off even after the thermostat stops (10 degrees or so higher.. ). I have done some research for the probable cause. The first one that I believe is not the case...

A/c shuts off temp never reached [ 5 Answers ]

My heat pump will run cooling mode for only about 30 min. or so. Then the outdoor unit shuts off. The indoor fan keep blowing. The smaller line going into the evaporator freezes between the evaporator and a valve with a capillairy tube that leads to the larger line. Once it thaws which takes about...

Cycling on-off before desired temp is reached [ 2 Answers ]

GMP100-3 gas furnace: The furnace runs for 3-5 minutes then shuts itself off for 2-3 minutes then repeats the start- stop cycle. I turned the thermostat up but it still acts the same. Any tips would be appreciate

View more questions Search