Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Flange bolts broke off in cast iron flange
[ 7 Answers ]
After laying tile in a bathroom, we tried to remove two flange bolts from a cast iron flange, but the both broke off flush with the flange. They were too short to begin with, but now we can't even get them out. It's as if they're rusted in. What can we do?
Closet flange broke pvc
[ 1 Answers ]
I recently installed ceramic tile in my bathroom. The toilet worked its way loose, I tried to tighten the bolt and it came out of the groove. So I pulled the toilet up and put the bolt back in I also replaced the wax ring. After reinstalling the toilet this happened again. So I decided to take...
Options for fixing this closet flange and bend
[ 10 Answers ]
I'm putting in a new tile floor that after leveling and cement board will raise the floor by at least one inch. So I must raise this cast iron flange. (OD 4-1/4”) However, I'm not sure what option I should use. You can see it is very corroded. Do I try to find an extension to raise it? (If so,...
I broke the flange under my toilet...
[ 13 Answers ]
The bolts rusted, and broke on my toilet -- so it slid around and broke the seal. I went to the hardware store to buy a wax ring, and ended up with a rubber boot that said it was "easier and less mess". I put it on the toilet, tightened it too much and cracked the flange on both sides. It's a...
Need assistance with shower flange that broke off
[ 2 Answers ]
Hi all: I was replacing the shower flanges that connect the water pipe in the wall to the shower head, and had to use some force to get it off. In the process, I broke off a part of the threaded flange in the pipe in the wall. I don't want to tear apart the wall. Any suggestions? FYI, I'm... View more questions Search
|