Ask Experts Questions for FREE Help !
Ask
    mikemmm's Avatar
    mikemmm Posts: 11, Reputation: 1
    New Member
     
    #1

    Jan 31, 2010, 01:53 AM
    Tub surround with no drywall behind it
    I will retype my question. I am thinking of purchasing a new home. While viewing the home which is still under construction, ( almost finished Interior work to be done) I noticed the tub surround has no sheet rock or greenboard behind it. I can see the insulation and vapour barrior. How should I expect that the contractor doing this work to seal at the top of the surround. The tube surround is a one piece shower and tube surround. It almost seems as if the whole unit was to large to fit and they cut away the drywall to fit it in place or maybe this is normal? Note two of the walls are exterior facing walls. I can take some pictures and email or post them of Facebook tomorrow if that helps. Thank Mike.
    KUXJ's Avatar
    KUXJ Posts: 975, Reputation: 97
    Senior Member
     
    #2

    Jan 31, 2010, 02:05 AM

    Hi! mikemmm, welcome to AMHD :)

    I have heard of installing tub surrounds like you describe, without any backer-board, From here I can't tell whether it applies to your situation.

    Pixs would be nice, You can create Attachments with AMHD's download manager. If you use your Facebook site you will need to link them to here.

    And mike, It would have been better if you would have edited or answered your original post.
    No harm done though, One of the mods will probably come through, and clean it up.

    K
    KBC's Avatar
    KBC Posts: 2,550, Reputation: 487
    Ultra Member
     
    #3

    Jan 31, 2010, 07:14 AM

    This is a normal installation for new surrounds.

    The use of drywall would be used for units with 3 or 4 piece units,not one piece.
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
     
    #4

    Jan 31, 2010, 08:58 AM

    Agreed, this is normal installtion. Your one one piece surround is the only surface needed. Greenboard would be a waste of time and money since not a drop of water will ever touch it.
    carpenter-t's Avatar
    carpenter-t Posts: 88, Reputation: 19
    Junior Member
     
    #5

    Feb 3, 2010, 03:54 PM

    This is normal as been stated.the green board if using joint compond or blue board if plastering should be installed over the nailing flange of the tub sorround.
    mikemmm's Avatar
    mikemmm Posts: 11, Reputation: 1
    New Member
     
    #6

    Feb 3, 2010, 10:17 PM

    Thank you for your help to this question. I have been through a number of homes under construction and understand why this is the way it is. The tub surrounds are in during the framing stage or just after insulation and poly go in. I just purchased a new home still under construction so I am sure I will have more questions. Except for maybe HVAC as that is what I do for a living.
    KUXJ's Avatar
    KUXJ Posts: 975, Reputation: 97
    Senior Member
     
    #7

    Feb 4, 2010, 08:02 AM

    Your welcome Mike. It is better to ask questions now, than after the paint dries.

    Don't hesitate 'bout any HVAC questions either.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Finishing drywall against a shower surround [ 15 Answers ]

What is the best method for finishing the drywall edges when placing them over the panels of a 3-piece, pre-fab shower surround unit. I know caulk is an option but it's 5/8" greenboard and it would seem that you would need a pretty perfect cut to make this look good seeing as it's the most visible...

Replacing drywall behind tub surround [ 3 Answers ]

Hi, we are repairing wall before installing new surround. The drywall does not match flush to the tub lip. Do we just make it fit or leave it above the lip? Read some post that leave me confused about the 1/8 inch thing.

Trying to find a one piece tub surround to fit a large jet tub [ 1 Answers ]

I recently purchased a home with a large juccuzzi jet tub (measures 73" long, 36" deep, and I can go as high as 78" to my ceiling) . I would like to put in a new tub surround, however, I have talked with rona, home depot, and many renovators in my area and they all are telling me that I can not...

Replace Sunken Tub with New Tub & Surround [ 0 Answers ]

I have a 34 year-old tiled concrete sunken roman tub that's too ratty to even think about soaking in. Besides that, the stopper's gone and the whole thing needs to be updated. It's currently being used as a step-down shower. Some dimensions: Length 57", Width 27 1/4", Depth 11"(only 6" after I...


View more questions Search