Ask Experts Questions for FREE Help !
Ask
    Kraken's Avatar
    Kraken Posts: 3, Reputation: 1
    New Member
    		  
    #1

    Jan 28, 2010, 07:31 AM
    Lennox g61MP series electric not working right
    Weird problem, our electricity got turned off before that everything was fine, when our electric got turned back on our furnace refused to work, but the weird thing is, if we plug in a generator to it, the furnace works fine, the status light is red but if there is no generator hooked up to it it does not blink at all.
    Kraken's Avatar
    Kraken Posts: 3, Reputation: 1
    New Member
    		  
    #2

    Jan 28, 2010, 07:33 AM

    Also where is the fuse in the furnace could that be blown?
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #3

    Jan 28, 2010, 07:35 AM
    You best be checking for the proper voltage from your main panel to your furnace. If it runs off a generator then the furnace is OK and the electric service from your home panel has a problem somewhere.
    Kraken's Avatar
    Kraken Posts: 3, Reputation: 1
    New Member
    		  
    #4

    Jan 28, 2010, 07:44 AM

    What's main panel? Doesthat mean thermostat? That's on and everything
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #5

    Jan 28, 2010, 09:01 AM

    The electric panel is in your home. Just because the circuit breaker is turned on does not mean that electric from the house panel is getting to your furnace. Just because your electric got turned back on does not mean that there is not another problem with your electric system. You need to use an electric test meter and sound out the system to find the offending part or circuit that is causing the problem.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Lennox furnace elite series [ 4 Answers ]

Problem with Lennox Elite Series... Burners will start but blower motor will not... can you cast any light on the subject... Thanks signed... Cold Chicagoan

Lennox elite series gas furnace [ 0 Answers ]

I set the thermostat at 70 degrees,the house is currently 63 degrees... the heater comes on, I see the flame and hear the blower,but it will only work for 2 minutes at a time.I cahnged the battries in theHoneywell electric thermostat but there was no change. Is there a way to troubleshoot(other...

Lennox G41 Series [ 2 Answers ]

My Lennox Furnace G41 Series keep blowing the 3 amp fuse on the printed circuit board Furnaceguru :cool:

Furnace Fan stays on - Lennox G61MP Series Units [ 2 Answers ]

Hi, My Furnace fan started this morning and is now on for the whole time. I tried switching off-on the Furnace mains but as soon as I start the furnace again, the fan starts. I have just switched off the home Thermostat that controls the overall heat in the house (its in my passage) and now the...

Lennox G40 Series blowing fuses [ 1 Answers ]

I have a Lennox G40 Series furnace that keeps blowing the 5 amp fuse on the circuit board. Unit will come on, burners will ignite, blower comes on & 5 min later, "pop". I've replaced the programmable thermostat to no avail. Put the old original thermostat back on that didn't work either. However...

View more questions Search