Ask Experts Questions for FREE Help !
Ask
    rubi874's Avatar
    rubi874 Posts: 1, Reputation: 1
    New Member
     
    #1

    Jan 12, 2010, 07:07 PM
    Bryant code 14 on 345mav
    The thermostat is calling for heat, 69 deg, the temperature is only 58 and furnace is in lock down showing error code 14. The furnace is a Bryant 345mav. If I cycle the power to the furnace off and then on again, the furnace will start and run in a normal fashion for a couple of hours then locks down. I cleaned the sensor but still no luck
    Any advice please

Check out some similar questions!

Bryant plus 90 350mav code 34/14 [ 5 Answers ]

I have a Bryant 350mav that is giving a code 34 followed by a code 14 . I checked the intake and exhuast pipes and they are clear. What next? It is blowing cold air, cycles the 3 times and then locks again.

Bryant Plus 80 Code 33 [ 10 Answers ]

I have a Bryant Plus 80 that is throwing a error of 33 (limit or flame roll out switch is open). The last time this happened was because the hot surface igniter was broken (frequent problem as my furnace has a tendency to short-cycle). I had picked up a couple extra ones so I had them on hand to...

Bryant code 42 [ 1 Answers ]

When the furnace is given the self test all appear to run fine the inducer hi and low, blower high and low and igniter glows. Furnace shuts down after about 2 min on high output. Could it be the control board?

Bryant code 33 [ 1 Answers ]

Bryant gas funace model 310aav042090aaja. Code 33. Wired around limit and it worked fine. Replaced with new limit throws code again. Vents clear. Filter clear. What next? Is it really getting too hot? Runs about 4 minutes before throwing code and cycles down about 3 minutes.

Bryant plus 90 code 43 [ 0 Answers ]

I have a Bryant Plus 90 series. I'm getting a code 43. From what I gather in my search, does it have anything to do with the blower motor?


View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.