 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Johnson control ignition module g600ax-3
I have a Lennox furnace with a Johnston Control ignition control G600ax-3 which I am unable to locate to replace. I ordered a universal White Roberts 50D50-843. The G600ax-3 has a spark igniter connection similar to a spark plug connection and the WR is a spade connector, do I have to replace the igniter or can I replace the existing connector with a spade connector or is it recommended to change the igniter assembly? Also is there a wiring diagram available for the Johnston G600ax-3?
|
||||
|
||||
|
Your instructions are below. I suggest that if you do not know what you are doing STOP and find someone local that can wire it for you. There is a severe liability that follows the changing of these type of SAFETY controls. I suggest you contact White Rodgers in regards to there selection of ignitor and pay close attention about the cable length and stand off requirements. Whatever you do follow the instructions especially the setup and key selection etc. Your old Johnson control wiring has nothing to do with the new White Rodger unit and the old control wiring should not be used as a reference.
http://www.white-rodgers.com/wrdhom/.../0037-6576.pdf |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
This is my very first post so... Hello everyone. and here is my question: I am replacing a Johnson Controls Pilot Gas Ignition control unit with a Honeywell 8610U and I am a little confused on how to connect all the wires. The wiring on the Johnson Controls unit is as follows: Main Valve...
My problem with my Lennox furnace (model G23Q-3/4-100-2) is blowing cool air, and only occasionally heat was diagnosed as needing a Universal Pilot Module, part #53L9001 also known as 53L90. Question, if we purchase the part how difficult is the installation?
I would like to know where is located the computer of ford mustan 1992
This is my first time post. Hello everone Here is my question: I am replacing a Johnson Controls CSA49A-600R with a White Roger 50D50-843 and I am a little confused on how to connect all the wires. Greatly appreciated any advice on how all the wires would go to the White Roger 50D50-843 unit....
I have a 1991 Ford Ranger 4 wheel drive with the 2.3L 4 cylinder engine. It has new wires, coil packs, and crank shaft position sensor. There are no burnt wires, fuses, or fusible links. There are also no chafed, pinched, or loose wires or connections in the harness yet I keep burning the Ignition...
View more questions Search
|
