 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Trouble shooting a Concord furnace
Our rental has a concord furnace , the indoor blower runs all of the time , no voltage to the ignitor . I checked all of the limits ,and the all check good. They said when they noticed the problem that the filter was being sucked into the compartment , indicating to me that it was dirty and needed replaced . The LED was flashing a fault of the high temp limit switch. I checked all limits and the operation of the preasure switch , all good .I tried resetting the board but the fault wood not reset. My Idea is to replace the board first. I also checked to see if there was voltage to the ignitor and there wasn't .
|
||||
|
||||
|
Usually the only problem a dirty filter will cause is a trip on high limit. Usually a call to the owner will get someone to fix it. None of my tennants are allowed to work on the furnaces as well as all the other goodies in the homes I own. They usually mess it up worse than when it first broke.
|
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
I have a Goodman GMPN060-3 gas furnace. My ignitor will glow and ignite the burner but will go out in just a few seconds. I have replaced the ignitor but still have the same problem. The furnace will try to ignite three times before shutting down. Sometimes it will ignite and continue burning on...
My concord furnace blower works but the burner will not ignite,after a few seconds the blower shuts off.
I have a payne furnace which is not woking,the code flashes 24,and it says something about a 24 vac line open,how do I repair this
Hello I have a Altra 90 SX Armstrong furnace that has a cycle problem. The model # is a GUK75D103A with a Heatcraft control board 404030001 Cat. # 70K98 The problem that I'm actually having is that it is going through its cycles OK, except the induced fan keeps running and won't shut off. ...
I have an Coleman Evcon Furnace. Model #15020A the problem is I replaced the Inducer motor, and The furnace starts like normal but then the flames goes out after about a minute or two. The LED light says the Pressure switch is stuck open but it seems fine. I tried to replace the PC board but can't...
View more questions Search
|
