 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Sounds like a pressure switch problem. Take the top door off the furnace. Look for the vent motor. There will be a small rubber tub coming off going to a round switch. Take that tube off and gently blow and suck into it. This should free the switch. Also chck to make sure the vent motor is spinning and not making a loud noise |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
My concord furnace blower works but the burner will not ignite,after a few seconds the blower shuts off.
My furnace is blinking 3 times and won't turn on. I have a Trane XR80 and no manual or trouble shooting codes. Could somebody please tell me what it means when it blinks red 3 times and won't turn on? Thanks... very cold:confused:!!
Hello I have a Altra 90 SX Armstrong furnace that has a cycle problem. The model # is a GUK75D103A with a Heatcraft control board 404030001 Cat. # 70K98 The problem that I'm actually having is that it is going through its cycles OK, except the induced fan keeps running and won't shut off. ...
I have an Coleman Evcon Furnace. Model #15020A the problem is I replaced the Inducer motor, and The furnace starts like normal but then the flames goes out after about a minute or two. The LED light says the Pressure switch is stuck open but it seems fine. I tried to replace the PC board but can't...
I have a gmp075-4 gas fired furnace, I just replaced the gas valve and the thing starts up fine but when the burner fires and the hot bar goes out the burner goes out any ideas? Limit switch maybe ?
View more questions Search
|
