Ask Experts Questions for FREE Help !
Ask
    malishafox's Avatar
    malishafox Posts: 1, Reputation: 1
    New Member
     
    #1

    Jan 6, 2010, 06:40 PM
    Where is the valve that turns on my gaslog fireplace
    Where is the valve located to turn on my gaslog fireplace
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
     
    #2

    Jan 6, 2010, 07:07 PM
    It could be almost anywhere but usually it is located within site of the unit. There are no specific code sectioins that address this issue with the exception that there has to be a shut off valve before the union to take apart the pipe. This valve could be located in the basement or elsewhere according to the National Fuel Gas Fire Code.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Water handle turns wrong way after I installed new water valve [ 6 Answers ]

Water handle turns wrong way, after I installed new water valve

Trane furnace turns off prematurely; valve gets very hot [ 1 Answers ]

Although my question sounds similar to other topics, this is very different. I think a gas valve component is getting abnormally hot! My furnace will turn on, the gas burners will light, and blower will turn on for about 5-10 minutes, enough to move the temp up 2 or 3 degress. Then the furnace...

White Rogers Hot Water Control Valve Turns on But Not off [ 3 Answers ]

I have a hot water heating system with three zones. This past summer all three control valves were replace, old ones were leaking, and three new thermostats installed I don't think the system ever worked after the installation but it was summer and we weren't using the heat. The new control...

No gas supply, or faulty valve in gas fireplace? [ 4 Answers ]

We use a regency Gr55-3 ~20,000btu gas fireplace for heating our bedroom. Its about 10 years old and has given us no trouble before. The gas supply line is a small (3/8"?) flexible copper tube that runs about 40' from a prv. I believe the prv lets pressure down from 2psi to a few inches of...

Gas Fireplace Turns Off [ 1 Answers ]

Hello, I have a gas fireplace that usually will start by turning on the switch right away (sometimes it does not and will take a couple of tries) however after about 20 minutes the fireplace will usually turn off by itself. Then after another 20 minutes it will turn back on. There is no...


View more questions Search