Ask Experts Questions for FREE Help !
Ask
    franssell's Avatar
    franssell Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Dec 31, 2009, 08:29 PM
    Joining PVC to Lead Pipe
    Hello,

    I was wondering if its OK to join pvc to lead pipes. The lead pipe seams to be in good condition and if I had more access, I'd replace the lead pipe all together. However the access to the cast iron pipe to the lead pipe is very difficult to get to. This has thinking that I'll leave a foot of the lead and attach my pvc to that. I'm currently remodeling the entire bath room.

    Thanks,

    Frans
    massplumber2008's Avatar
    massplumber2008 Posts: 12,832, Reputation: 1212
    Senior Plumbing Expert
    		  
    #2

    Jan 1, 2010, 05:50 AM
    Hi Franssell...

    If the lead pipe is in exceptionally good shape then it is fine to attach PVC to it using a FERNCO COUPLING (see image). Just be sure that the lead pipe is in great shape as it will only be harder to get to in the future should it be necessary... ;)

    MARK
    Attached Images
      
    franssell's Avatar
    franssell Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Jan 1, 2010, 02:59 PM

    Hello Mark,

    Thank you for your response. The lead pipe look really good.

    I appreciate your help. I'm pressing on with the project.

    Frans
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Does older PVC pipe fit with newer PVC pipe [ 6 Answers ]

I need to replace the piping underneath my sink and the union I bought does not thread up with the old existing part. If I use a new 1 1/2" coupling, will it fit snuggly with the old existing 1 1/2" pipe or have the sizes changed over the years. I will have to cut the pipe and install a coupling...

Joining hub and spigot pipe to PVC [ 1 Answers ]

I am trying to make a repair to my drainage system and the existing drain is ran in hub and spigot. I am trying to do the repair in PVC, but the PVC pipe will not fit into the compression gasket of the hub and spigot. Is there something I can do to make this work or do I have to use hub and...

Joining 4" PVC sewer pipe [ 1 Answers ]

I am replacing 4"PVC sewer pipe with the bell and spigot ends with the gasket in the bell. How do you get the two ends to go together? I've tried dish soap and vaseline as lubricants but cannot get the two ends to connect... any ideas?

Connect PVC pipe to a lead pipe [ 2 Answers ]

Hello, We live in an old building from 1900 together with other 3 owners. The main sewer pipe of the building is main of lead and one apartment has connected his own sewer pipe to the main lead pipe. This connection is now leaking, we would like to know which one is the best way to make such a...

Replacing lead pipe with pvc [ 9 Answers ]

The lead pipe and drain from my father-in-laws' bathroom is leaking and needs to be replaced. I'm tempted to just remove all of the lead (only a few feet) and cast iron all the way to the entry into the main discharge. Currently the 2 pieces of cast iron have a leaded seal. How do I connect...

View more questions Search