Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
My briggs and stratton engine will not crank
[ 6 Answers ]
the 17.5 hp I/c ohv engine on my riding lawn mower will not crank.(model # 31x707) the crank shaft will spin seemingly at the same speed as the starter gear when I turn the key to try to start it, but the engine doesn't even try to turn over, it just spins. The crank shaft spins on both the top of...
Fuel in crankcase, Briggs & Stratton engine
[ 3 Answers ]
I have a Toro mower with a Briggs & Stratton engine (model: 312777. Type: 0128E1), OHV 4-cycle, single-cylinder, 17 hp. I am getting lots of fuel in the crankcase. (float needle issue? ) Also, what is factory compression? I am getting about 65. Steve
Briggs & Stratton Engine Crank Weak
[ 2 Answers ]
I have an old MTD tractor. It has an 18 HP Briggs & Stratton engine. When I try to start it, the engine turned, but crank very weak. I charged the battery overnight and fully charged. I got the same symptom. The engine crank week. I felt the cable on the battery, and they got hot. Is it...
16.5 HP Briggs and Stratton OHV no fuel to engine
[ 1 Answers ]
I have a 10 year old Sears mower with a Briggs and Stratton 16HP OHV engine. Last week it started blowing tons of white smoke and stopped running. After some research I decided to change the head gasket and generally clean up the engine. Changed the gasket - no problem, cleaned the bypass valve,...
14.5 hp. Briggs & Stratton fuel leakage
[ 2 Answers ]
When the fuel tank is filled in my Poulan lawn tractor, gasoline flows into the cylinder freely. The only way to start engine is remove spark plug, drain fuel from cylinder, replace plug and start. Some valve is defective somewhere. Any suggestions about finding problem? I installed an in-line fuel... View more questions Search
|