Ask Experts Questions for FREE Help !
Ask
    fassey's Avatar
    fassey Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Dec 21, 2009, 09:18 PM
    Code 21 gas valve relay
    Is the gas valve relay a replaceable part or do I have to change the board thanks
    KISS's Avatar
    KISS Posts: 12,510, Reputation: 839
    Uber Member
    		  
    #2

    Dec 21, 2009, 10:44 PM

    Typically not replaceable and not sold as a spare part. Some mfr's make it difficult to do so even if you had the tools.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Carrier Natural Gas Furnace main gas valve will not open every call for heat [ 1 Answers ]

We have a Carrier Weather Maker 8000 Natural Gas Furnace not functioning properly. We have replaced pressure switch, hot surface ignitor, flame sensor and control board. It will cycle 3 to 4 times and then not come back on. Is it possibly a bad coil on gas valve?:rolleyes:

Flexi vs. Black iron gas line to water heater gas valve [ 3 Answers ]

I have seen gas water heater " install kits" that use the yellow flex appliance line for the gas connection to the gas valve on the water heater. My tank was installed when the house was built and has black iron pipe all the way to the union and into the valve on the tank. I have heard some codes...

Connection to gas range gas line too large for gas line intake valve [ 2 Answers ]

Connection to gas range gas line too large for gas line intake valve. How can I step the range back line down a step. Is there some kind of converter I can buy?

Maytag gas dryer, replacing gas valve coils [ 5 Answers ]

Hi, I hope someone can help me. My Maytag gas dryer's igniter glows but then no flame appears. I believe it is the gas valve coils that are bad, so I purchased a replacement kit (3 coils). The instructions say to match the colors of the wires, but my replacement kit has red, black, white...

Gas valve noise on main valve engagement [ 1 Answers ]

I have a carrier 58gs100ga furnace with a white rodgers 36e93 gas valve. The main gas valve solenoid chatters or rattles for a split second before it stays engaged after the pilot is proved. I just replace the spark/lock out board and the fan board for a different problem. This chatter is...

View more questions Search