Ask Experts Questions for FREE Help !
Ask
    glenb50's Avatar
    glenb50 Posts: 2, Reputation: 0
    New Member
     
    #1

    Nov 27, 2006, 11:47 AM
    Colman electric furnace
    I have a colman electric furnace in a late 80's mobile home. When the thermostate turns on the heating elements get hot but the fan will not start for 3 to 5 minutes. It will start after this time and run out the cycle. What keeps the motor from starting in this 3 to 5 minutes? Yes it is turned off till I get it repaired.
    labman's Avatar
    labman Posts: 10,580, Reputation: 551
    Uber Member
     
    #2

    Nov 27, 2006, 12:19 PM
    Older furnaces used a limit switch to turn the blower on after the furnaces heated up. The switch could be dirty, not making good contact, or just gotten old. Look for it on the heat exchanger. Clean it up and make sure it is in firm contact with a clean area of the heat exchanger. If that doesn't get it switched on a little sooner, replace it.
    NorthernHeat's Avatar
    NorthernHeat Posts: 1,455, Reputation: 132
    Ultra Member
     
    #3

    Nov 27, 2006, 03:36 PM
    But the fan does come on, right? It is perfectly normal for the burner to light and heat up the heat exchanger before the fan comes on.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Thermostat Wiring for Electric Furnace [ 2 Answers ]

I'm want to install the thermostat on our Electric Furnace. The wire leading to the furnace is a two wire (BLACK AND WHITE WIRES) It's heat only. The thermostat has a W and an R on the back of the stat. The furnace terminal has Y,W,O,C,G,F. The WO has a jumper between them? The W has a White...

Buzzing From Electric Furnace [ 2 Answers ]

I have a Trane heat pump system. As I tried the emergency heat position for the electric furnace, nothing happened but a "buzzing" sound. The tech was here twice and checked control panel, wiring, transformer, etc. Heat pump is fine... just when you turn on to emergency heat - inop. Tech was a...

Electric furnace problem [ 1 Answers ]

I have an old coleman electric furnace which is not working properly. The problem is that when the blower will quit when it is supposed to but the heating coils keep heating no matter what I do with the thermostat. I have had to cut the unit off at the breaker to stop the unit from heating. Any...

Intertherm 53,000btu electric furnace [ 1 Answers ]

The heating element turns on, and off in a few seconds, but the blower doesn't take off. Any suggestions would be appreciated.


View more questions Search