Ask Experts Questions for FREE Help !
Ask
    npatka's Avatar
    npatka Posts: 2, Reputation: 1
    New Member
     
    #1

    Dec 12, 2009, 10:39 AM
    How to loosen brass fittings on bathtub faucet
    I cannot loosen the brass fittings on a bathtub faucet with a wrench. Will heat help to loosen the fittings?
    speedball1's Avatar
    speedball1 Posts: 29,301, Reputation: 1939
    Eternal Plumber
     
    #2

    Dec 12, 2009, 10:47 AM

    These are brass to brass connections.
    Squirt some WD-40 on the threads and put some muscle into it. Good luck, Tom

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Plastic pipe brass fittings? [ 6 Answers ]

Can I use brass compression fittings with 15mm plastic pipe? Thanks!

How to loosen brass fittings [ 1 Answers ]

I cannot loosen a bathtub faucet with a wrench. Will heat help to loosen the brass fittings?

Brass pex fittings [ 1 Answers ]

Can you reuse brass pex fittings again if the crimp doesn't take? If so , How do you get the crimp off? Thanks beth

Braided PVC tubing and brass insert fittings [ 5 Answers ]

In the process of replacing a pressure tank on a well water system I have to make up some new connections using 1" ID and 3/4" ID braided PVC tubing and brass insert fittings with pipe clamps. What is the best way to get the inserts into the tubing? Would the heat from a hair dryer be helpful? ...

Removing brass fittings from Cast Iron pipe [ 3 Answers ]

I need to snake the line under my bathroom sink. The problem is I have a dual sink setup. The vent pipe is also connected there so I have a cast iron cross fitting where the four meet (the two sink drains, the vent pipe, and the drain to the main line). I was attempting to remove one of the...


View more questions Search