Ask Experts Questions for FREE Help !
Ask
    djay0270's Avatar
    djay0270 Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Nov 27, 2009, 03:25 PM
    Where is the gas valve coils on my dryer
    I have a Whirlpool Gold gas dryer and cannot locate the valve coils?? Please help!

Check out some similar questions!

How to replace Coil kit for dryer gas valve (2 coils, new style) [ 4 Answers ]

RE: Whirlpool Gas Dryer How to replace Coil kit for dryer gas valve (2 coils, new style)?

Carrier furnace gas valve opens too late [ 7 Answers ]

I have a carrier weathermaker downdraft heat&ac unit that fails to open the gas valve soon enough after the ignitor is glowing before it cycles through another attempt or "locks out". With the inducer motor running and ignitor glowing good either nothing else happens or a hissing noise like a...

Replacing Honeywell VS8421D2003 Nat Gas valve [ 1 Answers ]

I have a Pyromaster vent-free fireplace. The pilot light will light, but when I turn the gas valve to the "on" position, the pilot light shuts off. Any suggestions? The valve is a Honeywell VS8421D2003, Reg 3.5 Hi 1.7, 30 mV power unit. I have replaced nothing so far.

Model 36C03 gas valve connections [ 3 Answers ]

I need to install a White-Rodgers Universal Standing Gas Valve model 36C03 on a Colemand mobile home furnace model 7670A. The old control which was made by General Controls is absolete and had three small gas lines labeled vent, pilot, and one on top that was not labeled. I can figure out the vent...

Maytag gas dryer, replacing gas valve coils [ 5 Answers ]

Hi, I hope someone can help me. My Maytag gas dryer's igniter glows but then no flame appears. I believe it is the gas valve coils that are bad, so I purchased a replacement kit (3 coils). The instructions say to match the colors of the wires, but my replacement kit has red, black, white...

View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.