Ask Experts Questions for FREE Help !
Ask
    patti1950's Avatar
    patti1950 Posts: 2, Reputation: 1
    New Member
     
    #1

    Nov 17, 2009, 09:09 AM
    Gas furnace and cooking stove sounds like a blowtorch
    Furnace sounds like a blowtorch when the gas valve opens but it also happens with my cooking stove. I have had the gas company check it 2 other times because it was just every now and again, but now it happens every time the furnace kicks on. All they told me was the regulator is fine. If it was just one or the other I would think the furnace or stove was bad but not both at the same time.
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
     
    #2

    Nov 17, 2009, 12:01 PM
    I am with you on this one. Usually that sound indicates to high of a operating pressure. If both units are doing this the there is only one common denominator and that is the gas line pressure. Is it propane or natural gas? How do the flames look? Are the flames moving away from the orifice with a gap between the orifice and the flame?
    patti1950's Avatar
    patti1950 Posts: 2, Reputation: 1
    New Member
     
    #3

    Nov 18, 2009, 09:55 PM

    It is propane. The flames are going straight up and I mean way up. They are blue on the bottom and yellow on top. How do I make the gas company understand something is wrong with the regulator?
    KC13's Avatar
    KC13 Posts: 2,556, Reputation: 99
    Ultra Member
     
    #4

    Nov 18, 2009, 09:59 PM
    Yellow indicates incomplete combustion, the result of too much fuel or not enough air. If more than one appliance is affected, it is very likely excess gas.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Bryant Plus 80 gas furnace won't ignite burners [ 6 Answers ]

I own a Bryant Plus 80 gas furnace. The fan will run if I set the thermostat to "Fan On" instead of "Fan Auto". But the burners will not ignite. I have followed the user manual instructions to re-start the furnace, but that didn't work. I have a gas water heater and it is heating so I know the gas...

Converting lp gas water heater to natural gas [ 3 Answers ]

Is it possible to convert a lp gas water to a natural gas water heater or will I need to get a new heater?

Carrier gas furnace code 31 [ 3 Answers ]

Hi. I have a Carrier gas (propane) furnace 58MCA100-11116 series 111. It shows a code 31. The evacuation blower runs for a short time then kicks off. The burners do not ignite. To date I have: replaced the pressure switch, checked in and out lines to the pressure switch for obstruction,...

Gas Furnace won't Light [ 1 Answers ]

I am trying to light my gas furnace in my house but it won't light. I light the pilot and when I turn the dial to on the flame goes away and no gas in going through! What am I forgetting or doing wrong?

Blowtorch sound when gas valve opens.Intertherm propane furnace. [ 1 Answers ]

I have an Intertherm model MGHA-056AAFC-05 propane furnace with pilot light in a park model trailer.Its 12 years old and used sparingly.Almost since day one it will intermittantly fire up with a blow torch sound and when the blower motor cuts in... the flame will go out and it will shut down. I...


View more questions Search