Ask Experts Questions for FREE Help !
Ask
    home_owner_k's Avatar
    home_owner_k Posts: 1, Reputation: 1
    New Member
     
    #1

    Nov 5, 2009, 10:30 PM
    Drilling holes in concrete slab for termite prevention
    My 2-storey house sits on a concrete slab. I am considering having some preventive work done for termites. The termite control companies I have contacted have suggested that they drill holes (small dia.) in a few places in the concrete slab to inject foam/prevention chemicals. I have a few questions -
    1) Will drilling into the concrete cause issues for the slab (e.g. cracking, loosening of the slab etc) ?
    2)One of the companies suggested drilling holes every one feet (in the patio and garage areas). Will this compromise the slab structure and the house in general ?
    3)Is there a possibility that the drilling might break an underlying water pipe ?

    Any alternative suggestions are appreciated.

    Thanks,

Check out some similar questions!

Drilling holes in ceiling joist [ 5 Answers ]

I am drilling holes through a 2x6 ceiling joist. How many 12/2 wires can you run through a 7/8" hole? I am drilling the hole in the center of the 2x6 (width wise). Where is the best to drill the hole length wise? Thank you for your help.

Drilling holes in galvanized steel [ 2 Answers ]

I'm attempting to drill a lot of holes in a galvanized steel garbage can. I'm finding it easier just to put nail holes in it, but of course they are not large enough. Should I just get a fatter nail, or am I going about this the wrong way:confused:

Drilling holes in floor joist [ 5 Answers ]

Hi ,I want to move a 3" abs ventpipe in a floor space. The floor joists are 2X10 and near the supporting wall .Can I drill the joist? Do I need to use plywood or 2X10 to sister the floor joist to make up for the weakening .thanks bman55golf

Drilling holes [ 2 Answers ]

I need to drill a4" vent hole for a water heater in side of my house to connect the venting. What is the best drill to use and any avice on problems imight run into?

Drilling holes in mirror [ 2 Answers ]

Hi, I've never drilled a mirror before and I need a little help, I'm mounting two wall sconces over a bathroom vanity and need two small mounting screw holes and a small hole to accommodate the wiring for each sconce. A 4' by 5' mirror is on the wall it sits in a bottom channel and is held in...


View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.