Ask Experts Questions for FREE Help !
Ask
    rdzierniejko's Avatar
    rdzierniejko Posts: 10, Reputation: 1
    New Member
    		  
    #1

    Oct 18, 2009, 06:25 PM
    Honeywell Focus Pro 6000 (Heat and A/C reversed)
    I recently purchased a loft. The unit had an existing "Mammoth -- Water Source Heat Pump" thermostat. I purchased a Honeywell Focus Pro 6000 to replace this. I have hooked up the new thermostat, but the heat and A/C are reversed. In other words, to get the heat working, I need to set the system to "cool". Instead of blowing cold air, it blows heat. What am I doing wrong? Thanks.
    KISS's Avatar
    KISS Posts: 12,510, Reputation: 839
    Uber Member
    		  
    #2

    Oct 18, 2009, 06:42 PM

    Page 11 of your manual setup function #2. Change to the other value. Default is 0. Chage to 1 if 0; Change to 0 if 1.
    rdzierniejko's Avatar
    rdzierniejko Posts: 10, Reputation: 1
    New Member
    		  
    #3

    Oct 19, 2009, 08:44 AM
    Worked perfectly. Thanks.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Vulcan CX90 and Honeywell Focus Pro 6000 [ 2 Answers ]

Hi, I'm trying to install a Honeywell Focus Pro 6000 controller to a Vulcan CX90 Ducted Heating Unit. There are 6 wires coming from the CX90 marked A,B,C,D,E & F. The wiring diagram for the CX90 is no help because all 6 wires disappear into a decoder unit. Can anyone offer any help on wiring...

Honeywell FocusPRO 6000 Install (TH6110D1005) - Replacing unknown model: pic included [ 9 Answers ]

I had no idea there were so many different types of thermostat configurations. So without fully understanding that, I purchased a Honeywell FocusPRO 6000 (based on ratings) to replace my current thermostat. The problem with the current thermostat is that I have no idea what the brand is. The label...

Hard wire focus Pro 6000 thermostat [ 1 Answers ]

I just installed a Honeywell focus pro 6000 programmable thermostat I have a boiler with a indirect hotwater tank and a taco sr502 switching relay.. On thermostat I wire red to r white to w and blue to c. On switching relay I wire white to on left termial and red to right termial which I had the...

I need to figure out where two wires go to a Honeywell 6000 [ 5 Answers ]

There are the basic two wires (red and white) that are coming out of the wall that run the zone for my hot water baseboard furnace. I am removing the standard dial, mercury thermostat and replacing it with the Honeywell Focus Pro 6000 (TH6110D1021.) In the wiring manual that came with the new...

Wiring a Honeywell Focus Pro 6000 [ 1 Answers ]

I have a Carrier Heat Pump (about 5 years old) that had a non-programmable White Rodgers thermostat 1F59-11. The configuration of wires for the old thermostat are as follows: C = blue wire G= green wire R = red wire O = orange wire W= white wire Y = yellow wire L = empty B = empty

View more questions Search