Ask Experts Questions for FREE Help !
Ask
    tomcarhonda's Avatar
    tomcarhonda Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Oct 14, 2009, 08:19 PM
    What length of metal do I cut to lower my honda 1-2 inchs?
    I need to remove the strut also, but I tried doing it and it was hard to get out.
    AND when I do get it out, what are some lengths that I should cut the metal on the coil springs to make Honda's ride height 1-2 inches lower?
    Scleros's Avatar
    Scleros Posts: 2,165, Reputation: 262
    Hardware Expert
    		  
    #2

    Oct 14, 2009, 09:13 PM
    I suspect you will need to post your Honda car/truck model to get an accurate response from someone with experience lowering that model. In the meantime, read Car Lowering 101.
    bahamut's Avatar
    bahamut Posts: 64, Reputation: 6
    Junior Member
    		  
    #3

    Oct 15, 2009, 06:45 AM

    Can I make a suggestion and say don't do it, cut springs are dangerous, I'm all for modifying a car but do it right and you won't have any issues down the track! :)
    tomcarhonda's Avatar
    tomcarhonda Posts: 2, Reputation: 1
    New Member
    		  
    #4

    Oct 15, 2009, 04:41 PM
    Cutting coil spring on 2000 honda Accord EX
    I am wanting to try out cutting coil springs to lower my honda. What are some lengths that I should cut the metal on the coil springs to make my Honda's ride height 1-2 inches lower? I know I shouldn't cut them and go buy lowering kits BUT I want to try it by cutting them.:)
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Converting Slope arc Length to Flat Arc Length [ 1 Answers ]

Hi, Given parameters are:- Slope arc length Angle on Slope

What is the standard length of a full size metal frame bed slat? [ 2 Answers ]

I am installing a metal frame bed and the box spring I am using had to be cut in half to install it on our third floor. Now we are moving to the second floor and I need to know the slat size for an existing metal frame.

1999 Honda Civic Gas Tank Metal Flap [ 1 Answers ]

My "check engine" light has been on for a couple of days now. In the manual, it says to make sure the gas cover was on tight. It wasn't - - it was on crooked so I replaced it and made it click. The manual says it should take 3-4 trips for the "check engine" light to go out. When I filled up...

View more questions Search