Ask Experts Questions for FREE Help !
Ask
    tmirra03's Avatar
    tmirra03 Posts: 3, Reputation: 1
    New Member
    		  
    #1

    Oct 6, 2009, 02:52 PM
    Toro 52" walk behind, clutch won't engage
    I have a toro proline 52" deck with a 15 hp kolher motor manual start no battery, when I engage the clutch it will run for a few minutes and then blow a fuse, we checked it out and now the clutch doesn't engage at all with the switch. We checked all the switches and all checked out good, the clutch engages when you put another battery source to it, and all the wires are good and all the grounds are clean. What is supposed to be the voltage going to the clutch at idle and at high idle? What else can I check??
    crigby's Avatar
    crigby Posts: 4,343, Reputation: 107
    Outdoor Power Equipment Expert
    		  
    #2

    Oct 6, 2009, 04:36 PM

    Hi,
    Toro has many manuals available onlie at:
    https://landscapersolutions.toro.com...2&userID=20161
    But with out a model number, it would be a very long search.
    Peace,
    Clarke
    tmirra03's Avatar
    tmirra03 Posts: 3, Reputation: 1
    New Member
    		  
    #3

    Oct 7, 2009, 01:12 PM

    I looked on this website and they did not offer much insight.

    The model number: 30292
    The serial number falls in the first category
    210000001 and up to 500
    crigby's Avatar
    crigby Posts: 4,343, Reputation: 107
    Outdoor Power Equipment Expert
    		  
    #4

    Oct 7, 2009, 04:32 PM

    Hi,
    Problems in the PTO switch or the delay module #P5 would cause it not to turn on with a functioning clutch.
    Peace,
    Clarke
    Attached Images
     
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

JD 160 Engine Shuts OFF & Clutch Will Not Engage [ 2 Answers ]

I have been using the mower for a while now. I replaced the battery for a regular 12V car battery. The mower starts fine but when I move the switch to get the blades spinning, the engine stops. Do you think I need a new clutch? Do you think the Battery is too powerful? Thanks for your help...

Craftsman 16 hp 42 in. Lawn tractor won"t engage when clutch is released. [ 1 Answers ]

Once the mower is started, the engine runs fine, until the clutch/brack pedal is released, then the engine quits. Where would be the first place to check for a problem? Grateful for any answers!:)Thanks!

The clutch does not engage on my Sears Craftsman 48' [ 1 Answers ]

Hello everyone! I am new at this and signed up because I have a problem. The electric clutch in my lawn tractor Sears Craftsman 42' do not engage the blades. It started normally and then it disengaged. It did the same for a couple of times and then it stopped engaging completely. Does any one...

Toro 37" walk behind cluch not engaging [ 1 Answers ]

Good Morning Everyone, This is my Toro 37” walk behind mower powered with Kawasaki fb460v engine. This mower is about 12 years old and used residentially. This is a manual start with no battery. The magnetic clutch fails to engage or will engage when cold but not when hot. Here are the tests...

View more questions Search