 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Repairing American Standard Shower stem
I have an American Standard Shower Stem (cold) that needs repair. However, I can not seem to disconnect it from the pipe. I will attach a picture of the stem and perhaps someone could tell me what wrench to use. Thanks!
|
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
I have a circa 1965 AS Heritage in the wall 3-handle tub/shower fixture. I believe it's a Hertitage Model "N 1012" or N 1020". The diverter works spoaratically - the water flows to the shower, but then abruptly stops. With the diverter arrow pointing down for the tub water flows just fine. The...
I have a single lever (actually a rotating knob) American Standard valve. It's stuck so that it doesn't allow any hot water (cold is fine) to pass. Last time this happened (that was about a year ago -- this particlar shower doesn't get used much), the plumber removed the face plate, took out a...
Hi, I installed a american standard shower valve in my shower and I hooked up the hot and cold supply lines backwards. Is there and easy fix to this I really don't want to cut a hole in the back of my wall to fix this. Thanks Stancy
I Have an old American Standard one handle shower only valve (approx 40 yrs old). I bought a repair kit from a plumbing parts store consisting of valve seats, o-rings compresto install the repair kit?sion springs, etc. Can I gain access to the valve from the shower, or do I have to cut a hole in...
I have an American Standard Reliant + shower head that drips. Have replaced the cartridge & still dripping. Actually water is slowly coming out of the pressure balancing unit even when the water line is shut off. Do I need a new pressure balancing unit? What are the check stops for (one on each...
View more questions Search
|
