 |
|
|
 |
Junior Member
|
|
Sep 25, 2009, 06:42 AM
|
|
Basement Bathroom
Hi,
Building a basement bath. Sink,toilet, washer,dryer only.
Everything is in place except the toilet. The room has walls and a door.
Would like to vent the room by adding a vent fan and utilize the existing
Dryer 4" vent pipe so that I do not have to drill another 4" hole.
The dryer and additional vent fan will utilize the same 4" vent pipe via a wye.
The additional vent is only for the toilet - Stink vent.
NO shower will be added.
Will this combo work OK?
Thanks
|
|
 |
Eternal Plumber
|
|
Sep 25, 2009, 08:01 AM
|
|
Wouldn't the bathroon vent blow limt back into the dryer when you ran it? Just asking! Tom
|
|
 |
Junior Member
|
|
Sep 25, 2009, 09:57 AM
|
|
Hi,
Good thought.. Certainly not sure. Would use a
"Wye" for the connection.
I also have an unheated crawl space that I could vent into. Perhaps this is better?
|
|
 |
Eternal Plumber
|
|
Sep 26, 2009, 06:43 AM
|
|
I think venting to the crawl space would work better. No matter what you used to connect the vent to the dryer exhaust it will put air pressure in the dryer line that would blow both ways thus blowing and lint in the line back into the dryer. Good luck, Tom
|
|
 |
Junior Member
|
|
Sep 26, 2009, 12:18 PM
|
|
Hi,
I think I've talked myself into the crawl space vent.
Thanks
|
|
 |
Eternal Plumber
|
|
Sep 26, 2009, 04:40 PM
|
|
Good choice! Tom
|
|
 |
Plumbing Expert
|
|
Sep 26, 2009, 04:49 PM
|
|
Good call. You can not use the same vent for dryer and exhaust fan period. Running vent into crawl space is even questionable. If you can get the vent into crawl space, just run it out right above the sill plate with vent termination and your all set. Lee.
|
|
 |
Junior Member
|
|
Sep 26, 2009, 06:52 PM
|
|
Hi,
I'm going to utilize the crawl space and hopefully vent through the sill.
I'll only be using the vent for "Stink" no
Shower in the room.
Thanks
|
|
 |
Plumbing Expert
|
|
Sep 27, 2009, 02:06 PM
|
|
Sounds like you are on the right track. Good luck with your project. Please keep us posted. Lee.
|
|
 |
Junior Member
|
|
Sep 27, 2009, 02:12 PM
|
|
Thanks I will
|
|
Question Tools |
Search this Question |
|
|
Add your answer here.
Check out some similar questions!
Basement bathroom
[ 4 Answers ]
I recently purchased my first home, it is a town home with an unfinished rear walkout level basement. I would like to finish out the basement to include a laundry room, full bathroom and a living/recreation area with the possibility of a wet bar (all this will take time and I know that, as this...
Basement Bathroom
[ 1 Answers ]
When our house was built 5 years ago a basement bathroom had rough-in plumbing. What we have is a toilet flange, a 2 foot lavatory pipe coming up through the concrete and a square cutout in the concrete approximately 9 inches across. This square cutout is covered with a black plastic domed...
Basement Bathroom
[ 1 Answers ]
I am running pipes to the main sewer (running to septic) in my basement, trench is dug and ready to be plumbed, the main pipe is 4inch , here are my plans and the problem I have run in to, toilet 3inch drain, sink 2inch drain and shower 3inch drain will be connected into a 3 inch drain run approx...
Bathroom in basement
[ 1 Answers ]
We have a bathroom rough in in a basement with three pipes up from the floor one is obviously the toile but how do we know which is vent and which is drain? Or are both drains and the rough in is already tied to the vent?:
View more questions
Search
|