Ask Experts Questions for FREE Help !
Ask
    wil43's Avatar
    wil43 Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Sep 21, 2009, 01:56 PM
    Compresor not running
    Hello, my name is Wil43

    What is the problem when the condensing fan is running and the compressor is not running when the contactor is engaged ? :confused:Please help me .
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Sep 21, 2009, 03:51 PM
    With the power off check all the connections on the compressor then check all the power connections to the compressor capacitor and back to the contactor that activates the fan and compressor in the outside unit.

    If the capacitor looks swollen or is leaking oil it is probably defective and needs to be replaced. Always replace with the EXACT valve and voltage rate listed on the old capacitor.Again make sure the power is off. If you want to test the capacitors in your unit a simple OHM meter will test for continunity only. You need a real capacitor test meter to actually check for value. A industry standard of 6% is allowed for capacitor variation.

    Post back with the results of your adventure.
    Attached Images
       
    mygirlsdad77's Avatar
    mygirlsdad77 Posts: 5,713, Reputation: 339
    Plumbing Expert
    		  
    #3

    Sep 21, 2009, 05:14 PM

    Do you hear a humming noise from the compressor for a short time and then the noise stops(like its trying to start but won't?). THis would suggest a bad capacitor, a bad compressor, or incorrect voltage(possibly caused by contactor, or many other things). Your best bet is to have a pro tech into diagnose the problem. Good luck.
    JimmyTheAirGuy's Avatar
    JimmyTheAirGuy Posts: 15, Reputation: 0
    New Member
    		  
    #4

    Sep 22, 2009, 11:04 PM
    First thing you should probably do is turn the power off, remove the panel and inspect the electrical circuit for burnt wires, swollen run capacitor and burnt points on the contactor.
    You may want to try a start assist kit which consist of a start capacitor and a potential relay. If compressor still fails to start you may want to plan on replacing your compressor.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Outside compresor runs after t-state shuts down [ 3 Answers ]

T-state white-rodgers 1f58w-77, after temp reached the outside compressor keeps running. Might be a relay to compressor I'm thinking or t-state not disconnecting. Unit ac/heat pump Rheem. I shut down air handler from breaker, but the outside ac compressor still runs unless I power it off also from...

A/C compresor doesn't stay engaged. [ 4 Answers ]

I have a 97 neon that the A/C compresor won't stay engaged, it engages for about 5 seconds then disengages for about 5 seconds and it keeps doing that until I turn it off, and it doesn't get cold at all. I checked the charge and it's OK.

AC blower working but fan and compresor not [ 9 Answers ]

My AC fan stop working few days ago, we got a new fan motor , started the unit and the fan did not start. Changed the contactor and one of the capacitators and started fine until I shut it off the AC from inside and now the fan does not want to start. Any help will be appreciated.

Bath tub shower spout & head running water running at same time [ 1 Answers ]

I started with a slight dripping problem(sayko system).i decided to replace all 3 stem assemblies together as they all were about 18 years old.after reassembling the new stems(danko brand),turned on the water supply & checked faucets.hot & cold worked fine but when the shower was turned on,water...

View more questions Search