Ask Experts Questions for FREE Help !
Ask
    BBDinCT's Avatar
    BBDinCT Posts: 10, Reputation: 1
    New Member
    		  
    #1

    Aug 18, 2009, 04:31 PM
    Diverter Problem
    Quote Originally Posted by massplumber2008 View Post
    Hey BBDINCT:

    You use the 5/16" lag bolt to screw into the diverter spindle until it grabs well enough to put a pair of pliers on the head of the lag bolt and YANK the spindle forward....no need to go too deep. Be careful not to yank the valve out of the wall...;) Hold against yourself when pulling and it will come out. You may even need to push forward and then try to remove again. These can be stubborn!


    Good luck!

    MARK

    Thanks Mark!

    This worked out great.

    Jon
    massplumber2008's Avatar
    massplumber2008 Posts: 12,832, Reputation: 1212
    Senior Plumbing Expert
    		  
    #2

    Aug 19, 2009, 03:48 AM
    Glad we could help Jon! Thanks for the update.

    MARK
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Diverter Problem [ 1 Answers ]

I'm guessing the 5/16" bolt can be used to simply "unscrew" the stuck diverter valve by turning the bolt until it meets the back end of the diverter channel. I've done this and got the diverter valve 80% of the way out, but I think I need a longer bolt. I only used a 3" bolt. Thanks for...

1995 Altima Idleing problem Knock & O2 sensor, EGR Flow Problem [ 1 Answers ]

I have 1995 Nissan Altima with 67,000 miles. When the car is idleing when I start it or when it is at a red light the rpm's go from 6000 to 9000. It sounds like I am reving the engine. The engine sounds fine when I am driving the car ( rpm's are consitent). I went to AutoZone the read out errors...

Shower diverter problem [ 3 Answers ]

I have a Central Brass 3 handle tub/shower valve. It is old style with the larger seats. I replaced both valves, the diverter, and the seats. Now water will leak out of the shower in varying amounts if the water valves are opened most or all the way, even though the diverter is in the tub...

Diverter valve problem [ 1 Answers ]

Hi All, Had a problem with the diverter valve knurled end being worn, so I changed the whole valve(Danco replacement for Sayco). With the new valve, I have low pressure & also when putting water towards the shower head, it still comes out the lower spicket. How does that happen. Thanks in...

View more questions Search