Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Laminate flooring transition to raised vinyl flooring
[ 4 Answers ]
Installer put new 1/4' subfloor in bathroom last year when installing new Tarkett (vinyl) flooring, with a metal strip transition to existing hall carpet. Now we are installing 12mm laminate in hall, which with underlay, is approximately the same height. However, when the metal strip was removed,...
Laminate Flooring
[ 2 Answers ]
Hello All, We had water problems in our basement and need to put down a new floor. We would like to put down a laminate floor but am concerned because the temperature During the winter months gets down to about 50 degrees will this cause problems with A laminate floor?
Problems with laminate flooring/planks peaking
[ 3 Answers ]
We recently had some shaw 8mm laminate flooring installed. Very soon after the install, a few boards starting peaking up on the ends. I thought it was maybe touching a wall, but I read that the planks on both sides would push up against each other. We had the installer out and he says it's the...
Laminate flooring
[ 4 Answers ]
I purchased my laminate flooring today and was puzzled by what I was told. The location I purchased it from said that since the flooring I purchased came with the foam backing already attached to the planks then I did not need to purchase the roll underlayment, the form on the back was all I...
Laminate floor peaking and bridgeing
[ 7 Answers ]
:( Is there anything that can be done to repair laminate flooring that was apparently installed improperly? It was installed on cement that had not thoroughly dried. (Cement was used to level the floor) Also, glued the panels down. I have learned since the install that this should have not been... View more questions Search
|