 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Lost Well Pressure
I just put a whole house filter on my well. While doing so, I completely disconnected my well, reconnected, and primed it. But, I can only get 35psi. I originally had 45psi. Natually, it runs until I unplug it. How did I lose that 10psi? Do I just need to pump up the expansion tank?
|
||||
|
||||
|
Does that new filter have a bypass, if so engage it to see if the filter isn't throttling down the volume too much. Other folks have confused volume and pressure when they took their readings. Can you tell us how and where you got those reading and were any spigots open? |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
My water well has lost pressure, no water is coming out the faucet. What could be wrong
I have a drilled well system. The problem seems to occur after a power outage. I believe water is being used and the pressure in the pressure tank falls below the "cut-in" pressure of the switch and when the power comes back, the switch does not close to activate the well pump. Normally, I would...
Hi. I just replaced mu fitchen faucet and now I have very low cold water pressure in my master bath and laundry room.pressure is so low in tolliet that it won't fill. Help! I am lost
Out of the blue we have lost pressure at one bathroom sink?
We have an above ground water pump connected to an underground storage tank. We just had the tank filled, but there is no pressure in the pump. How do we re-prime to get it going again? Chuck
View more questions Search
|
