[topherjn88]

I need a picture of the drive belt off a 175 john deere hydro, my belt blew-out so I have no image of original routing, I bought a new belt and managed to fit it in and around both the tranny an the driving pulley. But I can't manage to figure out the routing around the guide and idler pulleys positioned near the middle under the tractor. I am stuck and would appreciate any help but a picture would be the best help for me.
-thank you!

[topherjn88]

Never mind I found a solution if you are in the same boat check this website out, it solved all my questions <http://outdoorpowerinfo.com/repairs/deere_175_drive_belt.asp>

[nathan81]

This doesn't look like my 175 hydro at all

[crigby]

Hi,
Do you have one of the rare Kanzaki(TuffTorq) transaxles? Only the last production used them. Everything before used a mating of an Eaton pump/motor assembly to a Peerless transaxle/differential. That is what that link covers.
If this is the case a bad picture is attached; the dashed line is the belt.
Peace,
Clarke