Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Compression Fitting
[ 28 Answers ]
I had a plumber do a rough-in for our new kitchen sink, including installation of the shut off valves, so that all I'd have to do was install the flexible hoses. Turns out, the sink we ended up with was deeper than we had anticipated AND we decided to go with a faucet that mounts on the side,...
Old compression nut and compression sleeve
[ 27 Answers ]
We have a shut off valve with a slow leak, about a teaspoonful every 10 hours. I want to replace the valve but the copper pipe to which it's attached is too short not allowing me to cut off the old compression sleeve. It's to my understanding that I may use the old compression nut and...
No compression
[ 3 Answers ]
I have a 2.4L twin overhead cam, the engine does not start, I did a compression test and they were as follows, from battery 156, 0, 165, 175... and It seems that every time I crank the engine I have oil splashing or such at the back of my engine bay... Any help or tips would be great thanks.
Compression vs. Solder
[ 6 Answers ]
Hi all. I have seen bits and pieces to the answer to my question in other posts, but not sure I have the complete answer, so I will ask it directly... Transitioning from copper to (C)PVC, are compression junctions adequate and/or recommended, or is it advisable to use soldered connections? ...
DVD Compression
[ 5 Answers ]
Unsure if this is the correct place for this question, but better here than nowhere. I have a Panasonic NV-GS11EB Digital Video Camera. This used 1 hour (standard use) mini cassettes. I have one such cassette with around 45 minutes of film. When I download this it creates a file anywhere... View more questions Search
|