Not your question?
  Ask your question
  View similar questions
   
  
 Add your answer here.Check out some similar questions!
Compression Vs Sweating
 [ 2 Answers ]
 Hello all! I need to replace a 1/2 dozen frozen valves in my basement that control water feeds up to 1st and 2nd floor bathrooms and kitchens. The current valves are sweat on. I am not that confident in sweating. Most of the lines are 1/2" one is 3/4". Can I remove these and replace with... 
Compression vs.  Threaded shutoffs
 [ 3 Answers ]
 How good in the long term are compression fit shut-off valves (for toilets and bathroom sinks) vs. good old threaded fittings for leaking? I have always used threaded fittings on 1/2" copper and wrenched on threaded 1/4 turn valves but in my new install am considering 1/2" compression for the 2... 
Compression test (Civic 91 DX)
 [ 2 Answers ]
 What can cause a compression test to show low compression on any cylinder? About half a year ago I went to check the compression at a local Honda Dealer, and they said 3 cylinders were OK and one was very bad. They said they poured some oil inside each cylinder and I got results of about 11:1 on... 
Image compression undo
 [ 1 Answers ]
 
I have 80 jpg images from the 'old' country of our ancestors. These are sent to us on two diskette. Unknown to us, these images are compressed. Is there anyway I can un-compress them as they look real bad. If not, how I can enhance them to make them better. I have photoshop but not knowing how to... View more questions Search 
  |