Ask Experts Questions for FREE Help !
Ask
    lpavo's Avatar
    lpavo Posts: 4, Reputation: 1
    New Member
    		  
    #1

    Jul 19, 2009, 02:52 PM
    Washer spin cycle whrilpool
    My waher would leave my clothes soaked so we relpaced the water pump, ring-balencer, the center post gasket. Before we put that stuff on I know the tub would spin fast well now it only spins slow or it doesn't spin but it sounds like something is going on. Do you think we put something on wrong? And how do you know if the drive block needs to be replaced? The agitator seems a lot higher now. Any ideas thank you Laura
    tickle's Avatar
    tickle Posts: 23,796, Reputation: 2674
    Expert
    		  
    #2

    Jul 19, 2009, 03:04 PM

    How long have you had the whirlpool ? Sometimes parts wear out from mega use. Mine did. I didn't repair, I just went out and bought a new washer and dryer because I didn't need the headache of not being able to do my laundry when I wanted to.

    Tick
    lpavo's Avatar
    lpavo Posts: 4, Reputation: 1
    New Member
    		  
    #3

    Jul 19, 2009, 03:12 PM
    Its only 4 years old and I just put all those parts on so I'm determind to fix it.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Kenmore washer 70 series humming at spin cycle - won't spin [ 4 Answers ]

RE: kenmore 70 series model 110.20712990 Type 111 top load washer. Won't spin. Humming noise and a little burning/hot smell when supposed to be spinning. Bypassing the lid switch did not correct the problem. Changed out the motor coupling with no luck... still a humming noise but no smell.

Spin cycle not working on washer [ 1 Answers ]

We have a Kenmore Elite washer model no. 110.20982992 and the spin cycle is not working. The water drains out of the washer and it sounds like it is spinning, but it is not. Any help would be greatly appreciated!

GE Washer won't complete spin cycle [ 1 Answers ]

I bought my washer used. It works fine, until it gets to the spin cycle. It starts to drain, and after a few minutes it will begin to spin and stops. However, if it has no clothes in the tub, it will complete the spin cycle. Once in a while, it will complete the cycle with clothes in it, but it is...

Whirlpool Washer Spin Cycle [ 1 Answers ]

Just bought a new whirlpool washer (MD#: WTW5790SQ0), the spin cycle on the washer doesn't work on any cycle EXCEPT normal wash. This was determined by: closing the lid, selecting each individual spin option on the dial and pulling the knob out (starts washer). Both spin cycles work on the Normal...

View more questions Search