Ask Experts Questions for FREE Help !
Ask
    dscampbell24's Avatar
    dscampbell24 Posts: 1, Reputation: 1
    New Member
     
    #1

    Jul 13, 2009, 02:14 PM
    Washer fills with water and that's it
    I have a kenmore 80 series, 3yrs old it will fill with water and that's it! Nothing else happens.
    HelpinHere's Avatar
    HelpinHere Posts: 1,062, Reputation: 144
    Ultra Member
     
    #2

    Jul 13, 2009, 02:44 PM

    Perhaps the motor is burnt out.

    Does it fill with water, and then just sit there full until you manually drain it, or does it drain itself when it normally would, without any washing.
    Does the machine buzz, hum, vibrate, or anything?
    maddie551's Avatar
    maddie551 Posts: 2, Reputation: 1
    New Member
     
    #3

    Jul 14, 2009, 09:37 AM
    Same thing happened to my kenmore washer it was the water fill sensor quick fix
    phillippeterson's Avatar
    phillippeterson Posts: 2, Reputation: 1
    New Member
     
    #4

    Jul 17, 2009, 03:08 PM

    Hi, It may also be the wigwag. I'm not pulling your leg. The first time I was told this I was skeptical. But, really, look it up. I replaced the wigwag and it worked fine after that. It may also be the water fill sensor as someone else mentioned.
    jenniepepsi's Avatar
    jenniepepsi Posts: 4,042, Reputation: 533
    Ultra Member
     
    #5

    Jul 17, 2009, 04:47 PM

    I'm not sure what a wigwag is, so if this IS a wigwag, I'm sorry for repeating info.

    But you know that little button thing, that is pushed down when the lid goes down? If that is stuck, then the washer won't do anything past filling. Because the lid needs to be closed to continue, and if the little button isn't down, then the washer thinks the lid is still open.

    Did that make sense/
    stuartn's Avatar
    stuartn Posts: 85, Reputation: 2
    Junior Member
     
    #6

    Jul 18, 2009, 05:05 AM

    It is not a wig wag if it is 3 years old. A wig wag is used pre 1990. Check your lid switch or the lid switch strike.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Kenmore Elite Washer - fills water and then pauses . It does nothing [ 2 Answers ]

It first showed CE error message. After some research on the internet I made sure the connections are correct and now it started and fills water after that it just stops and does nothing... it just waits.. I cancelled the cycle and restart a new cycle it fills water again and waits after it fills...

Amana washer fills,but nothing else [ 1 Answers ]

Amana washer fills but does nothing else,no noise from selector timer

Kenmore front load washer fills with water when not running [ 1 Answers ]

I will come back to my front load kenmore after it has sat Idle for several hours and there will be water in the washer and I have to run the drain cycle to get rid of it. I'm worried that it might overflow when I'm gone. Is there a fix? Thanks

Kenmore Washer fills but does not cycle [ 1 Answers ]

I have a 3 year old Kenmore Heavy Duty 2 Cycles 2 Spead Motor with 3 Speed Combinations washer. The washer has filled to the proper height but will not cycle to wash. Is there a reset or could it be the timer?


View more questions Search