Ask Experts Questions for FREE Help !
Ask
    red4arana's Avatar
    red4arana Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Oct 22, 2006, 07:37 PM
    It will not start
    I have a 6.5 intek pro briggs and Stratton pressure washers. It has been sitting outside and has not been started in about 2 months. 1. turn it on 2. put run starter on the bunny
    3. turned on fuel 4. put it on choke 5. pull ounces 6. put the choke on run 7. pulled one more time 8. pulled about 5 more times 9. It did not start 10. Put it in the heated garage for the night 10. Will try tomorrow 11. Now What Should I Different ? 12. HELP 13. I need this for my JOB the motor is very new I'm stumped? RED4
    thebriggsdude's Avatar
    thebriggsdude Posts: 1,096, Reputation: 53
    Ultra Member
    		  
    #2

    Oct 22, 2006, 07:53 PM
    Sitting outside... I'm guessing covered hopefully? There's a possibility (after 2 months sitting outside) of old stale gas.. water in the gas and carb... and a air filter that may have gotten wet (which will dry but it will close up choking it)
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

96 t/c Will not start [ 4 Answers ]

I have a 96 t/c that will not start and it sounds like the fuel pump is not kicking on.Do I need to drop the gas tank to take out the old one or is it somewere else. And does this have a reset switch on it if so where is it.Or should I replace my fuel filter.

Where to start.. [ 3 Answers ]

Im 17 and feel I'm to week I'm a bit of a couch potato I way 12 stone 4 and have decided to bulk myself up around the arms area that seems to be the area that needs the most work. I have started eating more healthey like diet ready meals, my 5 a day+ fruit and veg but bulking upwise I need advice...

XP won't start [ 5 Answers ]

Any suggestions on the following would be appreciated. Basically XP won't load up in either normal, or safe mode. It gets as far as that XP logo with the black background and sits there. The blue line in that loading bar at the bottom still moves, and the hard drive light blinks on and off...

Start up [ 1 Answers ]

Upon start up of my pc, the message "please check video cable connections" comes up. There is no web cam or video equipment connected to my computer. I then must shut down the system on the modem and start all over before the windows screen will come up. Could you help me resolve this problem?

View more questions Search