I have a 6.5 intek pro briggs and Stratton pressure washers. It has been sitting outside and has not been started in about 2 months. 1. turn it on 2. put run starter on the bunny
3. turned on fuel 4. put it on choke 5. pull ounces 6. put the choke on run 7. pulled one more time 8. pulled about 5 more times 9. It did not start 10. Put it in the heated garage for the night 10. Will try tomorrow 11. Now What Should I Different ? 12. HELP 13. I need this for my JOB the motor is very new I'm stumped? RED4

Sitting outside... I'm guessing covered hopefully? There's a possibility (after 2 months sitting outside) of old stale gas.. water in the gas and carb... and a air filter that may have gotten wet (which will dry but it will close up choking it)