 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
I have just removed an old ceiling fan. It had two switches... one that controlled the light and one for the fan. I am replacing it with a regular light fixture that has one white wire and one black wire. Problem is there is also a red wire and a green wire. Where do I put these extra wires? With...
I am trying to wire a pull chain switch to a fluoresent light. From the ballast there is a Black, White, on one side and a red wire and a blue wire on same side. On the other side, There are two reds and two blues. How do I connect the pull chain switch?
Is it OK to wire, 1 only, 220 volt, 1500w baseboard heater with 12/2 household wire and a 20 amp two pole breaker, with no neutral wire but making sure the grounds are connected at both ends?
I have a 2 story house with 2 electrical panels. The house was built in the 60s. I want to move the panel in the living room to the panel in the basement, an install with 200 amp service. How do I go about removing the panel in the living room to the one in the basement without doing a total...
I am getting ready to install a Dimension One spa that the manufacture calls for using #6-3 awg wire and 240 Volt - 50 Amp with a GFCI breaker and disconnect. I had the house pre wired for a hot tub and 240 Volt service. They installed a 50 Amp breaker in the main box and ran about 40...
View more questions Search
|
