Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
New sink vent and drain
[ 7 Answers ]
I want to add a sink between my washing machine and dryer. The washer drains into a fixture that has hot and cold water and a drain all in one box. If I cut into the pvc drain pipe below that and run a p-trap to the new sink do I need to install a new vent? If so does it go just after the p-trap? A...
Relocating Sink Drain/Vent to Dedicated Stack Serving Kitchen Sink & Dishwasher
[ 3 Answers ]
I am relocating an upstairs vanity sink from one wall to another (also going from single to double bowl). Rather than relocate the drain and vent pipe, I am hoping that I can tie into a 1-1/2" copper vent pipe that is located right behind the vanities intended location. The copper vent pipe is from...
Adding drain for washing machine - do I need a pea trap and vent?
[ 4 Answers ]
I am installing 2 new washers and dryers on each floor in our two flat in a kitchen pantry (the building is 120 year old frame building.) We are installing the wall insert that has the hole for the water coming in and a hole to put the drain hose going out. I know it has to be about 42" off the...
Adding a tub drain where a sink used to be
[ 1 Answers ]
I want to turn a half bath into a full bath in my basement. Currently the washer and dryer along with the water heater are in the half bath along with the commode and sink. I want to add a bath tub and the lay out of the room is such that the tub installation would probably require less work if it...
Kitchen Sink/Laundry Sink Drain Vent Non-exist
[ 3 Answers ]
The set-up from kitchen sink leading down to drain to basement: 1. Kitchen sink - (R side) - connected to a P drain I think you call it -PVC-, connected to a "metal" T, which has a Studer vent gizmo attached to the top of it, then draining into a metal pipe straight down to the drain in the... View more questions Search
|