Ask Experts Questions for FREE Help !
Ask
    gman2162's Avatar
    gman2162 Posts: 1, Reputation: 1
    New Member
     
    #1

    Jul 7, 2009, 03:00 AM
    Installing interior basement drain tile and sump
    I would like to know how to install drain tile around 3 of my basement walls and connect
    To a sump pump. I need to know how far down I need to dig? Where do I drill the holes in
    The block foundation to direct the water in to drain tile? What kind of pitch do the tiles need to have? And how do I work around hot water tanks or other obstructions?

    Thank you.

    gman2162
    hkstroud's Avatar
    hkstroud Posts: 11,929, Reputation: 899
    Home Improvement & Construction Expert
     
    #2

    Jul 7, 2009, 04:56 AM

    Dig down below footer. Punch hole in inner wall of each block cavity. Put 1/2" PVC pipe in each hole. Pipe should extend beyound footer. Try to trench level or slope toward sump (1/8 per ft). Line trench with nylon fabric cloth (weed block). Lay pipe with holes down. Fill with gravel to bottom of basement slab. Cover gravel with nylon fabric. Pour concrete.
    Dig hole for sump crock 6" larger than crock. Line hole with fabric. Set crock. Fill between crock and hole with gravel.
    Move water heater or tunnel under. Easier to move.
    Attached Images
     

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

How to install drain tile and sump pump [ 3 Answers ]

Can any one tell me how to install drain tile and sump pump pit.I know it is a lot of work but I have the ability and crew just need instructions

Tying a basement floor drain into sump basin [ 5 Answers ]

I am planning to install a floor drain in my basement which will discharge into my sump basin. Unfortunately, water on the floor will not flow into my sump since the lip of the liner is actually sitting on top of the slab, surpassing it by about a 1/4 inch. It was installed to collect water from...

Drain tile and sump pit and pump [ 3 Answers ]

Can anyone be more specific as to install drain tile and sump pit. Like how deep should I dig down around inside of foundation.How far from the foundation walls. Should I come out and how far from the wall should I place the pipe. Can I use 4 in plastic flex pipe? Should the concrete be cut with...

Is trapped drain in basement an alternative to sump pump? [ 4 Answers ]

Hi all, I have groundwater entering my basement during storms at one single point in the floor, and at no other place currently. It is earthen in the small area where the water enters. I can pinpoint the point of entrace with a pencil tip! The water drains down a worn channel about one foot in...

Toilet drain to Basement Sump pump [ 7 Answers ]

I want to add a bathroom in my basement. I was wondering if I could run my toilet drain into the sump pump hole. ( I have my own septic symstem and the drain leaving the house is 4ft. Above the basement floor). Also, would this need to be vented? The toilet would be about 6 to 8 ft. from the...


View more questions Search